by Engineering | Aug 23, 2020 | Trouble Shooting 1 Axis-Group, Trouble Shooting 2 Axis-Group, Trouble Shooting Grid Connect-Group
Commands or Data not reaching device After entering commands or data no changes appear in my screen. Trouble Shooting The cause most often is the screen is no longer updating. Refreshing through your browser or check the refresh button near the lower left of...
by engineering | May 23, 2019 | QSG-Group, Trouble Shooting 2 Axis-Group
Alarm Codes Control Versions: 1220.2.875.0, 1220.4.875.0, 2032.404.0 Trouble Shooting 1-Auto Disabled – Local Switch 2-Hold-No Simultaneous Motor Runs 3-Encountered Physical Max LS 4-Encountered Physical Min LS 5-Encountered Soft Max Limit 6-Encountered...
by engineering | Feb 25, 2015 | Brushless Motors, Tech Support, Trouble Shooting 1 Axis-Group, Trouble Shooting 2 Axis-Group
PROBLEM: My power supply cuts out every time my brushless motor stops. The controller reboots as well. POSSIBLE SOLUTION: Check that the current limit adjustment is set at 10 amps. As we use 10 amp motors there is no reason to set it higher as it can cause the...
by engineering | Aug 28, 2013 | Tech Support, Trouble Shooting 2 Axis-Group
Communicating to the Tracker IPm via the RS232 serial port is the preferred method if you wish to avoid IP addressing issues normally associated with Ethernet connections. Since the RS232 port B is an RJ45 connection, a converter is supplied in the box pre-wired. Use...
Recent Comments