by Alex Bryant | Dec 12, 2016 | 2 Axis Installation, 2 Axis Installation-Group
Start Procedure - Click Arrow > Open Project With your latest version of tool kit open File / Open Project Go to the folder where you placed the project file. Select the file then Open Serial Connection You may connect to your Tracker IPm by either serial or...
by Alex Bryant | Dec 12, 2016 | 2 Axis Installation-Group, Brushless Motor-Group, Getting Started, Quick Start Guides
Start Procedure - Click Arrow > WARNING This is only recommended for experienced users. For less experienced users we recommend configuring via IPWebcontrol NOTE The following assumes that Sixnet toolkit is installed on the computer and that the user is...
by Alex Bryant | Dec 8, 2016 | 2 Axis Installation, 2 Axis Installation-Group
Start Procedure - Click Arrow > INSTRUCTIONS Open Project with your latest version of tool kit open File / Open Project. Select the file then Open Serial Connection. Connect the RS232 port of your PC to the System RS232 Port B of the Tracker IPm. Most new PCs sold...
by Alex Bryant | Mar 11, 2015 | 2 Axis Installation-Group, Brushless Motor-Group
Connect your tracker to the internet via the ethernet port on top of module. Make certain that your network supports DHCP and allows browsing. If not, see your network administrator. Log on to your Web Control account here. In the dash board, select the Tracker IPm...
by Alex Bryant | Mar 6, 2015 | 2 Axis Installation-Group, Brushless Motor-Group, Getting Started, IPm WebControl, Quick Start Guides
Requires version 3.00 and higher This assumes that all Location (here) and both axis Motor set up has been completed, wiring is completed and you are ready to track the sun. Sometimes solar trackers can lose position due to mechanical slop, hysteresis or external...
by Alex Bryant | Mar 6, 2015 | 2 Axis Installation, 2 Axis Installation-Group, Brushless Motors, Trouble Shooting 1 Axis-Group
If the brushless motors for azimuth and altitude changes are not turning in the correct direction when using the manual switches use the following instructions to change the direction. The procedure involves switching the wiring for the reversing relays so that...
Recent Comments