by Engineering | Aug 21, 2020 | 1 Axis Configuration-Group, 1200 QS-Group, 2 Axis Configuration-Group
Setup & Configuration Control Versions: 1220.2.875.0, 1220.4.875.0, 2032.404.0 Configuration GRIDview RTU Configuration Master Enable: Master Enablement which permits all Control Processes Enable Tracking: Enables NREL SPA to calculate solar position...
by engineering | Jun 11, 2017 | 1 Axis Configuration-Group, 2 Axis Configuration-Group
Set Operational Limits Configuration MECHANICAL LIMIT SWITCHES Mechanical Limit Switches are wired to the tracker controller and provide physical limits to the tracker’s travel. These should be located at the furthest allowable point travel. It should...
by engineering | Jun 11, 2017 | 1 Axis Configuration-Group
1 Axis Controller Back Tracking is disabled by default but can be enabled in Toolkit by Toggling DO...
by engineering | Dec 9, 2016 | 1 Axis Configuration-Group
1 Axis Controller ESAT Enhanced Single Axis Tracking The Tracker IPm incorporates an ESAT algorithm to provide high accuracy throughout the day. Some controllers use the SPA Azimuth only for tracking which achieves good results at noon but not early and late in the...
by engineering | Aug 28, 2013 | 1 Axis Configuration-Group, 2 Axis Configuration-Group, Brushless Motor-Group
Controller Sinking or Sourcing Configuration Tracker IPm (except for Brushless motor applications) are generally shipped from the factory with Sourcing as the default setting. This is the common setting for brush motors. For some brushless motor controls...
Recent Comments