by engineering | Aug 29, 2013 | Anemometer-Group
Anemometer The Tracker IPm wind speed setup will accept pulse or 4-20mA inputs from any commercially available anemometer. You can set it up in m/s or mph as long as you keep the engineering units the same for all the variables ie: meters/sec or mph. Wind Speed...
by engineering | Aug 28, 2013 | 1 Axis Installation, 1 Axis Installation-Group, 2 Axis Installation, 2 Axis Installation-Group, QSG-Group
Complete Wiring & Power Up the Tracker IPm To begin with, down load the I/O Tool Kit software and install it on your Windows PC. You will be sent a TRACKERvxxx.6PJ project file and a registration file by email. Save them in an accessible folder on your PC. The...
by engineering | Aug 28, 2013 | 1 Axis Installation, 1 Axis Installation-Group, 2 Axis Installation, 2 Axis Installation-Group
Single Phase AC Three Phase AC
by engineering | Aug 28, 2013 | 1 Axis Installation, 2 Axis Installation
Requires version 3.00 and higher This assumes that all Location and both axis Motor set up has been completed, wiring is completed and you are ready to track the sun. Sometimes solar trackers can lose position due to mechanical slop, hysteresis or external forces. By...
by engineering | Aug 28, 2013 | Calibration 1200 Series-Group
Applies to Legacy Versions 1060 & 1200 Not applicable to Series 2400 Configuration Tools Standard Calibration is the simplest method of calibrating directly from tool kit. This assumes that all Location (here) and both axis Motor set up has been completed, wiring...
Recent Comments