by Alex Bryant | Dec 12, 2016 | 2 Axis Installation, 2 Axis Installation-Group
Start Procedure - Click Arrow > Open Project With your latest version of tool kit open File / Open Project Go to the folder where you placed the project file. Select the file then Open Serial Connection You may connect to your Tracker IPm by either serial or...
by Alex Bryant | Dec 8, 2016 | 2 Axis Installation, 2 Axis Installation-Group
Start Procedure - Click Arrow > INSTRUCTIONS Open Project with your latest version of tool kit open File / Open Project. Select the file then Open Serial Connection. Connect the RS232 port of your PC to the System RS232 Port B of the Tracker IPm. Most new PCs sold...
by Alex Bryant | Mar 6, 2015 | 2 Axis Installation, 2 Axis Installation-Group, Brushless Motors, Trouble Shooting 1 Axis-Group
If the brushless motors for azimuth and altitude changes are not turning in the correct direction when using the manual switches use the following instructions to change the direction. The procedure involves switching the wiring for the reversing relays so that...
by engineering | Aug 28, 2013 | 1 Axis Installation, 1 Axis Installation-Group, 2 Axis Installation, 2 Axis Installation-Group, QSG-Group
Complete Wiring & Power Up the Tracker IPm To begin with, down load the I/O Tool Kit software and install it on your Windows PC. You will be sent a TRACKERvxxx.6PJ project file and a registration file by email. Save them in an accessible folder on your PC. The...
by engineering | Aug 28, 2013 | 1 Axis Installation, 1 Axis Installation-Group, 2 Axis Installation, 2 Axis Installation-Group
Single Phase AC Three Phase AC
by engineering | Aug 28, 2013 | 1 Axis Installation, 2 Axis Installation
Requires version 3.00 and higher This assumes that all Location and both axis Motor set up has been completed, wiring is completed and you are ready to track the sun. Sometimes solar trackers can lose position due to mechanical slop, hysteresis or external forces. By...
Recent Comments