by Alex Bryant | Aug 27, 2019 | 2 Axis Configuration-Group, QSG-Group, ToolkitConfig-Group
Once the panel and tracker have been installed, the tracker will need to be calibrated. Please follow the steps below to calibrate. Configuration - 1200 Series Open up GRIDview to the page that contains all available listed trackers.Check that the limit switch is...
by engineering | Jun 4, 2019 | 2 Axis Configuration-Group, QSG-Group, ToolkitConfig-Group
When the controller is first received or GRIDview is not available for configuration use this instruction for on-board motor control switch testing using Toolkit. Configuration - 1200 Series In Test I/O open tab D IN follow these settings: X20 masterEnable ON X20...
by engineering | Jun 3, 2019 | 2 Axis Configuration-Group, QSG-Group, ToolkitConfig-Group
When the controller is first received or GRIDview is not available for configuration use this instruction for initial soft motor controls testing using Toolkit. Configuration - 1200 Series In Test I/O open tab D IN follow these settings: X20 masterEnable ON X20 Track...
by engineering | May 23, 2019 | 2 Axis Configuration-Group, QSG-Group, ToolkitConfig-Group, Trouble Shooting 2 Axis-Group
Tracker Version – using GRIDview Configuration Tools 1-Auto Disabled – Local Switch 2-Hold-No Simultaneous Motor Runs 3-Encountered Physical Max LS 4-Encountered Physical Min LS 5-Encountered Soft Max Limit 6-Encountered Soft Min Limit 7-Motor Reversal...
by Alex Bryant | Dec 13, 2016 | QSG-Group, Trouble Shooting 2 Axis-Group, Uncategorized
To Begin Calibration - Click Arrow > Note This assumes that all Location and both axis Motor set up has been completed, wiring is completed and you are ready to track the sun Getting Started Connect your Tracker to the Internet via the Ethernet port on the top of...
by Alex Bryant | Dec 13, 2016 | 1 Axis Installation, 1 Axis Installation-Group, 2 Axis Installation, 2 Axis Installation-Group, QSG-Group
Start Procedure - Click Arrow > Complete Wiring of IPm Click to View Slide I/O Toolkit To begin with, down load the latest I/O Tool Kit software and install it on your Windows PC. You will be sent a TRACKERvxxx.6PJ project file and a registration file by email....
Recent Comments