by Alex Bryant | Aug 27, 2019 | 2 Axis Configuration-Group, QSG-Group, ToolkitConfig-Group
Once the panel and tracker have been installed, the tracker will need to be calibrated. Please follow the steps below to calibrate. Configuration - 1200 Series Open up GRIDview to the page that contains all available listed trackers.Check that the limit switch is...
by engineering | Jun 4, 2019 | 2 Axis Configuration-Group, QSG-Group, ToolkitConfig-Group
When the controller is first received or GRIDview is not available for configuration use this instruction for on-board motor control switch testing using Toolkit. Configuration - 1200 Series In Test I/O open tab D IN follow these settings: X20 masterEnable ON X20...
by engineering | Jun 3, 2019 | 2 Axis Configuration-Group, QSG-Group, ToolkitConfig-Group
When the controller is first received or GRIDview is not available for configuration use this instruction for initial soft motor controls testing using Toolkit. Configuration - 1200 Series In Test I/O open tab D IN follow these settings: X20 masterEnable ON X20 Track...
by engineering | May 23, 2019 | 2 Axis Configuration-Group, QSG-Group, ToolkitConfig-Group, Trouble Shooting 2 Axis-Group
Tracker Version – using GRIDview Configuration Tools 1-Auto Disabled – Local Switch 2-Hold-No Simultaneous Motor Runs 3-Encountered Physical Max LS 4-Encountered Physical Min LS 5-Encountered Soft Max Limit 6-Encountered Soft Min Limit 7-Motor Reversal...
by engineering | Jun 11, 2017 | 1 Axis Configuration-Group, 2 Axis Configuration-Group
Configuration MECHANICAL LIMIT SWITCHES Mechanical Limit Switches are wired to the tracker controller and provide physical limits to the tracker’s travel. These should be located at the furthest allowable point travel. It should be configured with N.O. and 1...
by engineering | Aug 28, 2013 | 1 Axis Configuration-Group, 2 Axis Configuration-Group, Brushless Motor-Group
Configuration Tracker IPm (except for Brushless motor applications) are generally shipped from the factory with Sourcing as the default setting. This is the common setting for brush motors. For some brushless motor controls digital inputs must be Sinking so here is...
Recent Comments