by engineering | Aug 27, 2013 | Uncategorized
Calibration 2 Axis – Cloud Tracker Version – using GRIDview Configuration Tools This assumes that all Location (here) and both axis Motor set up has been completed (instructions using: Sixnet Toolkit, or IPWebcontrol), wiring is completed and you...
by engineering | Aug 27, 2013 | Tech Support
UNDER CONSTRUCTION Tracker IPm’s are shipped from the factory set for DHCP and should automatically run on any network provided there is a DHCP server. If you need to change DHCP to a static IP address follow this procedure: In Toolkit high light the Tracker IPm...
by engineering | Aug 27, 2013 | Tech Support
UNDER CONSTRUCTION Firmware Firmware version 4.3.163
by engineering | Aug 27, 2013 | 1200 Wiring Diagram-Group, 2 Axis Wiring Diagram-Group, Brushless Motor-Group
2 Axis Brushless Motors Selectable 1x / 2x Wiring Diagrams This drawing provides a simplified overview on how everything connects to motor controllers. See the next diagram for wiring to the motors. The feedback utilizes the pulses from the drive motor Hall...
by engineering | Aug 27, 2013 | Tech Support
Normally the Tracker IPm with update its clock via the Internet when connected to your local area network. If you need to set the clock manually using your laptop use the following procedure. Open the Sixnet Toolkit project that accompanied your product. In the Menu...
Recent Comments