Sun Sensor ISS-TX
- Turn Off Power to the Controller.
- Connect the Red wire to the Plus on the 12VDC power supply.
- Connect the Blue wire to the Negative on the 12VDC power supply.
- Connect the Yellow wire to terminal 20 (+RS-485) on the controller.
- Connect the Green wire to terminal 21 (-RS-485) on the controller.
- Connect the Grey wire to terminal 19 (GND) on the controller.
- Place a 120 Ohm resister between terminals 20 & 21 as shown.
This wiring is valid only for Model VT-MIPM2M-113.
Once wired and powered up, the user should see data in Analog Input registers AX201 through AX210. Register 211 though AX214 may not show values until the sensor is placed outdoors and has a radiation level of 700 or more.
Solar Position vs. Output
The chart to the right shows the Additional numeric information provided by the sensor (Tag: Add_info), it’s meaning and how the controller will respond in order to correct.
Troubleshooting
If data does not appear in registers
Check controller model number is VT-MIPM2M-113
Turn ON Digital Output Y201 enableSSensor_MB
Check Power Supply has the correct polarity
Check that RS485 has the correct polarity
Check that RS485 ground goes to terminal 19
Check the resister is 120 Ohms plus or minus 5 Ohms
Check the RS-485 cable is shielded twisted pair.
Additional Information
Binary | Information | Comments | Movement Correction |
0 | No information | Obtaining FOV values | |
255 | Zero radiation | Angles values set to 0º Radiation not enough: less than 300 W/m2 | Out of Available Options |
51 | Sun is out of FOV | Angles values set to 0º | Out of Available Options |
1 | Sun is out of FOV | Angles values set to 0º Sun is to X positive reference | Move Tracker East |
2 | Sun is out of FOV | Angles values set to 0º Sun is to X negative reference | Move Tracker West |
16 | Sun is out of FOV | Angles values set to 0º Sun is to Y positive reference | Move Tracker Up |
32 | Sun is out of FOV | Angles values set to 0º Sun is to Y negative reference | Move Tracker Down |
17 | Sun is out of FOV | Angles values set to 0º Sun is to X positive and Y positive reference | Move Tracker East and Up |
18 | Sun is out of FOV | Angles values set to 0º Sun is to X negative and Y positive reference | Move Tracker West and Up |
33 | Sun is out of FOV | Angles values set to 0º Sun is to X positive and Y negative reference | Move Tracker East and Down |
34 | Sun is out of FOV | Angles values set to 0º Sun is to X negative and Y negative reference | Move Tracker West and Down |