by engineering | Aug 28, 2013 | 2 Axis Installation, 2 Axis Installation-Group
Sunset Stow Position If you wish to have the Tracker go to a predefined position at sunset, enter the position in degrees. Caution: Entering 0 (zero) will cause the tracker to stay in last position at sunset. If you wish to utilize Auto Cal at each sunrise do not...
by engineering | Aug 28, 2013 | 1 Axis Installation, 1 Axis Installation-Group, 2 Axis Installation, 2 Axis Installation-Group
This information is important for the accuracy of the tracking system. If you do not know the location’s Latitude, Longitude and elevation, then any GPS device including an automobile GPS can give you what you need. Find your Latitude & Longitude by City...
by engineering | Aug 28, 2013 | 1 Axis Installation, 1 Axis Installation-Group, 2 Axis Installation, 2 Axis Installation-Group, Sensors-Group
Applies to Legacy Versions 1060 & 1200 Not applicable to Series 2400 Position Sensors Operations / Test I/O The Tracker IPm is a closed loop system which means it requires a position feedback in order to operate. It can be configured to accept motor pulse or...
by engineering | Aug 28, 2013 | 2 Axis Installation, 2 Axis Installation-Group
Open Project With your latest version of tool kit open File / Open Project Go to the folder where you placed the project file. Select the file then Open Serial Connection You may connect to your Tracker IPm by either serial or Ethernet. To avoid local network issues,...
by engineering | Aug 28, 2013 | 1 Axis Installation, 1 Axis Installation-Group, 2 Axis Installation, 2 Axis Installation-Group, QSG-Group
Install Toolkit You will be sent a project file (Next_Gen_V3060_x.6PJ ) and a registration file (TRACKER CONTROL RegData..6rg) by email when the Tracker IPm is shipped. The names may be slightly different depending if you have some customization but the suffix should...
by engineering | Aug 28, 2013 | 1 Axis Installation, 1 Axis Installation-Group, 2 Axis Installation, 2 Axis Installation-Group, Tech Support
Sizing your power supply to the Tracker IPm correctly is very important. Note: By selecting the “Independent Motor Run” option in configuration, you need only to consider the current of one motor in a dual axis system. Example: A Kinematics...
Recent Comments