Alarm Codes – Series 2400

by | Jul 25, 2019 | Trouble Shooting Grid Connect-Group

2400 Series

 
RTU Alarm Code 1-99 Non Self Clearing (Permissives OFF until Alarms Manually Reset)
RTU Alarm Code 100-499 Self Clearing (Permissives OFF until Cleared)
101 Reboot Occured
102 Lost IP Address
111 Master Enable (Global Auto) is OFF
112 Axis 1 SPA type not defined
113 Axis 2 SPA type not defined
114 Axis 1 Sensor type not defined
115 Axis 2 Sensor type not defined
116 Axis 1 Hall Pulses/Revolution not defined
117 Axis 2 Hall Pulses/Revolution not defined
118 Altitude Solar Direction not defined
119 Azimuth Solar Direction not defined
122 SPA algorithm failed
RTU Alarm Code 500-999 Notice Only Self Clearing (Permissives Not Affected)
570 Axis 1 Azimuth Defined with Inclinometer
571 Axis 2 Azimuth Defined with Inclinometer
580 Remote I/O Modbus not enabled
581 No I/O enabled
585 In Wind Stow
589 AX1 in Self Calibration
590 AX2 in Self Calibration
591 In Pre-Dawn Position
594 ISaGRAF version changed
595 System Info Not Detected
597 Default Counts per Second Axis 2 maybe incorrect
598 Trackers in Stow
599 Tracking not Enabled
995 AX1 Not Calibrated
996 AX2 Not Calibrated
   
Station Alarm Code 1-99 Non Self Clearing (Permissives OFF until Alarms Manually Reset)
10 Minimum Limit Switch detected while Running Direct
Station Alarm Code 100-499 Self Clearing (Permissives OFF until Cleared)
104 Minimum Limit Switch encountered
105 Soft Maximum Limit encountered
106 Soft Minimum Limit encountered
200 Global Enable is Off
203 RTU in Alarm
204 Default Settings Reset
208 Remote DO Station Status Offline
209 Remote DI Station Status Offline
210 Axis 1 Sensor not defined
211 Axis 2 Sensor not defined
Station Alarm Code 500-999 Notice Only Self Clearing (Permissives Not Affected)
510 Min Limit Switch encountered
520 Pv cannot be forced - motors running
800 Night Stow